SDXTOOLS / INSTALLATION

SELECTION GUIDE

Electric Pipe Wrench Size Selection by Measured Diameter

Use measured millimetres as the selection input.

Measure the gripping surface

Nominal pipe size and outside diameter are different inputs. Record the actual connection dimensions rather than converting a nominal inch label into a presumed clamping diameter.

Read the overlap

For example, a 100 mm gripping diameter lies within the published 58–115 mm range of 20ET and 90–142 mm range of 25ET. Compare 8.0 kg versus 9.5 kg and 30 versus 18 r/min before discussing fit.

Check the edges

At 200 mm, only 50ET in this series includes that diameter in its 158–220 mm range. That still leaves material, geometry and access to confirm.

Measured diameter screening examples
Measured gripPublished shortlist
100 mm example20ET and 25ET include 100 mm. 20ET is lighter and faster on the published table; compare access before choosing.
200 mm example50ET is the only listed range that includes 200 mm. Confirm gripping geometry and material separately.

Ask SDX to review the fit

Use the checklist above to prepare the workpiece and access details.

Send an enquiry →